Overloads for our purposes can be understood by reference.
Circuit breaker frame size rating.
60 amp low voltage molded case thermal magnetic breaker must be able to open or close at 48 amps 80 of its rating or less.
The preferred continuous current ratings of the various frame sizes are listed in ansi c37 16.
And intended for continuous operation at 100 percent of rating shall be marked.
To determine the appropriate size of circuit breaker for single phase supply it depends on multiple factors like type of load cable material and environment temperature etc.
In the range of molded case circuit breakers conforming with the ul 489 and csa c22 2 standard abb proposes an entire range which covers current ratings between 15 a and 2500 a and interrupting ratings at 480 v ac which can reach 150 ka.
A circuit breaker having a frame size of 250 a or greater or a multi pole type of any ampere rating rated over 250 v.
And cedar rapids iowa respectively.
Although 100 rated devices typically are not available in sizes this small the permitted rating would still be 50a 16a 30a 46a.
Rounded up to 50a.
Frame size rating a circuit breaker which can be fitted with overcurrent tripping units of different current level setting ranges is assigned a rating which corresponds to the highest current level setting tripping unit that can be fitted.
The general rule of thumb is that circuit breaker size should be 125 of the ampacity of cable and wire or the circuit which has to be protected by the cb.
Interrupting ratings like 10k 22 5k and 65k rms ensure the breaker has an interrupting rating sufficient for the maximum possible fault current available on the line side terminals of the equipment.
Jim pauley is manager industry standards and sandi young is circuit breaker product specialist with square d co lexington ky.